New product
EZ-EYE™ miniature photoelectric sensors fulfill the need for an affordable, push-button sensor that is EZ to align and EZ to adjust. Optimized for machine control automation, the setup is easy with the unique one-touch AUTOSET routine. Simply place the sensor in the Light State condition and push the button once for a perfect setting.
This product is no longer in stock
Warning: Last items in stock!
Availability date:
SUPPLY VOLTAGE | 10 to 24 VDC |
CURRENT REQUIREMENTS | 50 mA (exclusive of load) |
OUTPUTS | (1) NPN and (1) PNP sensor output transistor Sensor’s output can sink or source up to 150 mA (current limited) |
DIAGNOSTIC INDICATORS | Dual Red/Green LED: Red - Output Status Green - Flash Rate Alignment Indicator Dual Green/Amber LED: Green - “ON” After AUTOSET™ Routine Amber - “ON” After Excess Gain Adjustment |
PUSHBUTTON CONTROL | AUTOSET™ Routine: Push and release with sensor in “light” state Excess Gain Adjustment: Tap twice to step to higher excess gain Push and hold to activate Flash Rate Alignment Indicator Light /Dark “ON” selection: Tap 5 times to toggle |
HYSTERESIS | Approximately 15% of signal |
RESPONSE TIME | 500 microseconds |
AMBIENT TEMPERATURE | -40ºC to 70ºC (-40ºF to 158ºF) |
RUGGED CONSTRUCTION | Chemical resistant, high impact polycarbonate housing Waterproof ratings: NEMA 4, IP67 Conforms to heavy industry grade CE requirements |
LIGHT SOURCE | Red - 660 nm Infrared - 880 nm Pulse Modulated |
LIGHT IMMUNITY | Responds to sensor’s pulse-modulated light source, resulting in high immunity to most ambient light, including high intensity strobes. |
MAXIMUM SENSING RANGE | Dependent on optical block |
EZ-EYE™ miniature photoelectric sensors fulfill the need for an affordable, push-button sensor that is EZ to align and EZ to adjust. Optimized for machine control automation, the setup is easy with the unique one-touch AUTOSET routine. Simply place the sensor in the Light State condition and push the button once for a perfect setting. |
EZ to select higher excess gain… just tap the button twice to increase the excess gain (sensitivity). Note: Initiating the AUTOSET routine followed by tapping the button emulates a screwdriver adjustment. |
Unique lensed optical blocks are molded of solid, optical-grade, high-impact plastic. This innovative concept helps to prevent condensation on the inside of the lens. Ten varieties of optical blocks are available for operating the EZ-EYE, such as retroreflective, polarized retroreflective, proximity, fiberoptic or convergent sensing modes. A simple change of the optical block can be very useful in determining the best sensing mode for your specific sensing task. These inexpensive, interchangeable optical blocks eliminate the need for discarding a complete sensor in the case of damage to the optical block. |
TheEZ-EYE™photoelectric sensor by TRI-TRONICS® fulfills the need for an affordable, push-button sensor that is EZ to align and EZ to adjust. |
FEATURES & BENEFITS
|
![]() |
![]() |